➤ How to easily repair and install a PC power button 🎮

An inconvenient time for users is when they cannot start the computer due to a power button failure. Fortunately, it is not mandatory to take your PC to a technician to correct this problem. Therefore, we recommend that you read this article in which we explain how to easily repair and install a PC power button

The power button

A power button is a switch that allows you to switch on and / or off an electronic device. This device turns on when the button is pressed once and turns off when the same button is held down. You can also configure the system to turn off the screen by pressing the power button in Windows and other computer components.

On a PC, the power button is usually located on the front and is used for turn on the power supply Of computer.

Types of power buttons

There are two types of power buttons: electric and mechanical. The electric start button is soft and does not change when pressed. While the mechanical power button makes a "click" when pressed and has depth when pressed to turn on a device.

How to easily repair and install a PC power button

Just as you can fix a risky damaged hard drive that won't boot or recognize Windows, you can also fix it the power button if it doesn't work. For this reason, we recommend that you carefully follow each of the following steps so that you can fix this small flaw.

Get a new power button for your PC

Before installing the power button, it is necessary purchase a new button to replace the deteriorated button from continuous use. Once this component has been obtained it is necessary to take into account some particular aspects such as those mentioned below.

Turn off your equipment completely

From the operating system, choose the "Shut down" option and wait a few seconds while the computer closes the session. When the screen turns off, disconnect the computer from the power source.

Disconnect the components from the motherboard

Locate and disconnect the monitor cable, network cable, keyboard, mouse, monitor, and printer patch cables. These cables are hidden in the back of the case or box. Therefore press and hold the button di power on to completely remove the residual energy stored in the power supply.

Open the case

Make sure you wear an antistatic wrist strap or touching a metal surface before opening the case. Then, open the case by removing the left case panel. For this, use a screwdriver that allows you to remove the two screws holding the panel from the back.

Pull out the power button

Place the case face up so that the main bezel (where the power button is) is facing left. Therefore, press the tab to release the frame located at the bottom right of the panel and push the right side of the bezel forward.

Press and hold the power button as you move the bezel so it doesn't come off on its own. Then, twist the button power cap several times to remove it. From the back, press the button so it pops out the front of the frame. You can use this step to clean your PC's power supply if you see dust or elements hindering its operation.

Install the new PC power button

Remove the damaged power button assembly spring and place it on the new button. Therefore, insert this button in the front of the frame and insert the plug on the stem from the back.

Close the case

Place the panel from where you initially removed it and tighten the two screws on the case. Finally, connect all the component cables to the front of the case. If, on the other hand, you find that you cannot shut down Windows giving the error that it does not shut down, check the operating system because there must be the cause of this problem.