Many times when an iPad device has some failures or errors, the simplest solution is between a soft-reset. However, on other occasions, due to a serious mistake like forgetting the password or because the device needs to be sold, people prefer to choose to factory reset iPad.
Some people may think that if your iPad stays on lock and won't boot or the iPad screen goes black while it's on, you should resort to changing your device. However, in most cases these problems are easy to solve with a guide on the Internet.
That's why today you will know the simplest steps to perform a hard reset or soft reset on your iPad, in case you have forgotten your password. Always with the best practices to prevent your iPad from restarting continuously without turning on.
How to perform a hard reset if I forget my iPad password?
The first thing you need to know is the difference between a soft reset and a hard reset, because if your iPad device only needs a reboot, you won't need to perform a factory data reset. Being that hard reset is a drastic alternative that will erase all information, while soft reset is normally used when the device is malfunctioning.
How to hard reset iPad?
If you already have completely forgot your iPad password, it is very likely that you need to factory reset your device. In the first case, if you haven't locked your device yet, the procedure might be a little easier to perform.
You have to quickly go to Settings> General> Reset. This will allow us to display the button » Delete all content and settings ". When you click on this option, a new section will say "Delete iPad", you just have to confirm.
Once this is done, the process will be completed and the setup screen should show as when it was purchased. It will be configured again and this would include a new password to be created.
How to perform a hard reset without password on iPad?
If your iPad device is locked and you can't log in when you don't turn it on because you can't remember your password, the process can be a little more complicated. But for this method, the access to a trusted computer it must be an essential resource.
That is, to restore the iPad to factory settings without the need for a password, it will be necessary that this device has already been previously connected to a computer for you to trust. In this way it would be sufficient to connect the iPad to the system and use the iTunes program to restore it.
In this scenario, the first thing to do is to connect the iPad to the trusted computer and once detected, launch iTunes. Within this, you will need to visit the "Summary" page within iTunes itself, where a backup section will appear and you will need to click on " Restore backup «.
At this point a pop-up window must have started, we will accept by clicking on the "Restore" button and we just have to wait for the device to restart.
How to perform a soft reset on an iPad?
A soft reset on an iPad is not the most viable option in case you have forgotten your password, as no data will be erased. But if for some other mistake the iPad does not allow you to enter the password, then it is the best alternative.
Soft restart on an iPad
For this you just have to hold down the power button until the cursor appears on the screen. In general, iPads show this control on the top edge when held upright, while on older models it is on the side.
Just drag the cursor left to right to shut down the iPad properly. Once the iPad is turned off, you will have to press and hold the power button again so that it boots and the Apple logo appears on the screen, completely finishing the restart.
