How to make a homemade Wifi signal booster or booster? - Step by step guide

For example, it is very common for some users to check WhatsApp or browse the internet while in the bathroom, but normally the Wi-Fi signal does not usually reach these sites. For this and many other reasons, Wi-Fi amplifiers have become fashionable.

However, these network amplifiers they are usually very expensive and as you might expect, not everyone can afford to spend part of their floor on them.But don't worry, luckily for you, there is a homemade solution to amplify the range of our wifi with which we can save money our money.




Later we will talk about 2 homemade methods so that you can make a very cheap signal booster, we also assure you that this process will take no more than 10 minutes. Even with these home WiFi repeaters you can maximize your internet speed.

How to make a homemade Wifi signal booster or booster? - Step by step guide

Wi-Fi signal amplifier with a can of beer

This method is quite simple to perform because you will only need a can of beer to be able to improve the Internet signal in your home. This way you can route the signal so that it can reach places far away from Wi-Fi.

That's why we encourage you to follow the instructions below to the letter so that you don't have a problem  make a home Wi-Fi signal booster with a can of beer and thus improve the Wi-Fi signal at home.

  • To get started you should search a can of beer and a utility knife, however you can also use scissors. The idea is to cut the bottom like the top.
  • Unlike the bottom of the can, the top does not need to be cut in its entirety. Remember to leave a piece of the can so that the top remains attached to the rest of the can.
  • Next, you have to cut in a straight line from the bottom to the top of the can, passing through the center to create a sort of satellite dish.
  • Now the top of the can will act as a stand or base for the rest of the antenna
  • This way we have already completed ours wifi antenna repeater.
  • In this step you will only have to pass the Wi-Fi antenna through the hole at the base of the repeater that we made with the can.
  • Then you can use adhesive tape to fix this satellite dish to wifi.
  • To finish you must direct the wifi antenna in the direction you want the router signal to be amplified.

How to make a homemade Wifi signal booster or booster? - Step by step guide




Using aluminum foil to enhance the router signal

Now, in this new section we will take the trouble to explain in depth everything you need to do to be able to amplify your Wi-Fi signal with aluminum foil. Undoubtedly, this other method for too build a home Wi-Fi signal repeater it is quite simple and also does not require special materials, as everyone has aluminum foil in their houses.

  • To get started, you'll need to carefully cut a cardboard the size of an ordinary letter sheet.
  • To continue, you must completely cover the cardboard you just cut with the aluminium sheet. In this case you will need to glue the paper to the cardboard with liquid glue or a bit of adhesive tape.
  • Once the glue has dried, you'll just need to place this aluminum foil right behind your router's antenna. The ideal is to place this sheet on a wall or fix it to it in order to be able to redirect the Wi-Fi signal to areas of our department where the signal was previously very weak.
  • On the other hand, it is important to note that with this method it is possible to reduce interference and protect the router from computer attacks. This way we will prevent third parties with bad intentions from having easy access to Wi-Fi.

Undoubtedly, a home signal booster will help us improve the internet of our WiFi router to play online games, connect in video conferencing, watch videos more smoothly and facilitate many other things we need to do on the internet.





add a comment of How to make a homemade Wifi signal booster or booster? - Step by step guide
Comment sent successfully! We will review it in the next few hours.